Product introduction
This product changes the form of traditional thermal insulation materials, and eliminates the joint in the form of continuous film formation of nano coatings to ensure the integrity of the thermal insulation layer, achieve thermal insulation effect, reduce energy consumption, and improve the living environment.

Application background
When floor heating is applied in construction, insulation board is laid to reduce heat loss, but the insulation board has the problem of lap edge, which is easy to cause the cold and hot bridge effect, and the thermal insulation board is easy to crack and damage due to its limited strength, which affects the thermal insulation effect. Therefore, it is necessary to carry out additional functions and guarantees for such routine practices.

Product advantage
1, excellent thermal insulation, partition heat downward loss
2, excellent high temperature resistance, good aging resistance
3, high economic efficiency, reduce energy consumption, heat source temperature rise fast
4, zero VOC, green environmental protection

Reference standard
T/CECS 10342-2023

Construction method
1, before painting operation, should ensure that the base surface clean, dry state construction.
2, before use, the beaded resin is easy to float on the top, please stir it fully (you can use an electric mixer), and then use the spraying construction method to properly improve the coating thickness, which can obtain greater performance.
3, inspection, repair, acceptance. Check the coating surface and trim the weak parts.

Recommended dosage
≥ 1.5kg /m²

Save:
1, storage conditions: cool and dry place, sealed storage, stored in a ventilated and dry place above 5 ° C, should avoid direct sunlight to prevent freezing in winter.
2, shelf life: under the premise of good storage, the original sealing condition shelf life is 12 months.
3, transport: according to non-flammable liquid transport.
4, abandonment provisions: unused waste and solidified waste is recommended to be treated by qualified treatment agencies or in accordance with local laws and regulations, do not pour into water or soil.

Matters needing attention
1, please ensure that the base surface is dry;
2. When the temperature is below 5℃, the humidity is above 85%, or there is condensation, please do not construct;
3, the work place should be well ventilated, the operation of the work is strictly prohibited fireworks;
4, the product is stored in a cool place, properly kept, stored and discarded, so as to avoid contact with infants, after opening, please use up as soon as possible.